7 Easy Steps

Installation Method for Under Tile

  1. With a clean, dry subfloor covered in backer board, place ClipStrip strapping along opposite facing walls approximately 2" from the outer wall.  Note: We recommend the first system test to be right out of the box.
  2. Mount your Delta-Therm thermostat inside of a standard electrical junction box.  The 2FW cable cold lead must be in conduit.  Notch out the wall's base plate and the backer board to run the conduit.
  3. Starting at your new thermostat loop the 2FW cable back & forth across the room.  Attach the 2FW cable to the clips on the strapping every 3" - 4".  Slide the 2FW cable under the clip to secure it in place. 
  4. Install the Delta-Therm thermostat temperature sensor through the conduit (recommended) and secure to backer board.
  5. Note: Here, we recommend a second system test before applying mortar over the 2FW cable.  You can also use our handy FloorWarner to audibly monitor the 2FW cable.  Embed Cable.
  6. Note: Here, we recommend the last system test.  Install your tile, marble, or stone floor covering according to the manufacturer's instructions. 
  7. Grout and seal tile, marble, or stone per manufacturer's instructions. 
7 Easy Steps
 

The Heat Cable Experts!

450 S. Main Street, Suite 1
Greensburg, PA 15601

TOLL-FREE PHONE
1-888-836-9136

FAX
724-836-9138

HOURS
Monday through Friday
8:00 a.m.-5:00 p.m. EST

sales@deltaelectrical.net

Delta Therm

Time Mark

 

Mono-Systems, Inc.

Dsg-Canusa

Champion Fiberglass

Fulham

Heatizon

Honeywell

EXM Manufacturing

 

Ohyama Lights

Paladin

Danfoss Heat Cables

Global Power Products

Dimplex

American Fittings

R-SCC

Cadet Heat

Renesola

Lotus LED lights

 

 

 

Free Joomla Templates by JoomlaShine.com